ExtCreations Signs Tutorial - Historical

Teleport up and down to different floors and levels along the y-axis. Your lift signs must be on the same x and z coordinate as its arrival pair.

All Lift signs need to be in pairs.

First Sign:
You will use [Lift Up] or [Lift Down]

• First Line: Blank
• Second Line: [Lift Up] or [Lift Down]
• Third Line: Blank
• Fourth Line: Blank

Example - These is an example of a Lift Up and Lift Down signs


You can also name each sign to give the destination a name. This name will go on the first line.

Example:

This will pop "First Floor" into your chat whenever you arrive at this sign.

Second Sign:
You have two options for your second sign of your Lift pair.
You can either create an arrival sign that will only let you arrive at the sign and not head back, or create a sign in which you can navigate back and forth between each sign.
If you wish to do a to/from sign, simply repeat the above steps for which ever direction you wish to travel with the second sign.

Arrival Only:
You will use [Lift]

• First Line: Blank
• Second Line: [Lift]
• Third Line: Blank
• Fourth Line: Blank
  Example:
  
  
  You can also name each sign to give the destination a name. This name will go on the first line.
  
  Example:
  
  This will pop "First Floor" into your chat whenever you arrive at this sign.
  
  Things to Note:
  • Lift Signs must be in the same column to operate correctly
    • Example:
  
  • Your arrival point must be on a solid block, and it will attempt to place you directly above or below where you are standing when you interact with a lift.
    • If you stand 3 blocks from the sign and interact, it will attempt to place you at the destination also 3 blocks in front of the sign (same x and z).
  • You can use the third and fourth lines of the sign to include information to a user about the destination, these lines will not impact the function of the lift.